radius-server retransmit (BNG)
To specify the number of times the Cisco IOS XR software retransmits a packet to a server before giving up,
use the radius-server retransmit command. The no form of this command sets it to the default value of 3 .
radius-server retransmit {retries disable}
no radius-server retransmit {retries disable}
Syntax Description
Maximum number of retransmission attempts. The range is from 1 to 100.
Default is 3.
retries
Disables the radius-server transmit command.disable
Command Default
The RADIUS servers are retried three times, or until a response is received.
Command Modes
Global configuration mode
Command History
ModificationRelease
This command was introduced.Release 3.7.2
This command was supported on BNG.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The RADIUS client tries all servers, allowing each one to time out before increasing the retransmit count.
Task ID
OperationsTask ID
read, writeaaa
Examples
This example shows how to specify a retransmit counter value of five times:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# radius-server retransmit 5
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
46
BNG AAA Commands
radius-server retransmit (BNG)
To Next Page
Loading...
Need help?
General
