show dhcp ipv4 proxy binding
To show information concerning DHCP client bindings for proxy, use the show dhcp ipv4 proxy binding
command in the EXEC mode.
show dhcp ipv4 proxy binding [circuit-id circuit_id_name| detail| interface| ipspecifier| location|
locationspecifier| mac-address| remote-id| summary]{location| vrf| vrf_name}
Syntax Description
Displays the DHCP IPv4 proxy client binding based on circuit ID.circuit-id
Displays the name of the circuit ID.
circuit_id_name
Displays detailed binding information for DHCP proxy.detail
Specifies the interface based on which the DHCP bindings are filtered.interface
Displays the name of the interface.
ipspecifier
Specifies the node location of the DHCP proxy.location
Displays the name of the location.
locationspecifier
Displays detailed client binding information based on mac-address.mac-address
Displays the DHCP IPv4 proxy client binding based on remote ID.remote-id
Displays the summary binding information for proxy.summary
Displays the VRF information.vrf
Displays the name of the VRF.
vrf_name
Displays the output modifiers.|
Command Default
Displays brief information about all DHCP proxy client bindings.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
195
BNG DHCP Commands
show dhcp ipv4 proxy binding
To Next Page
Loading...
Need help?
General
