exclude
To specify a range of IPv4 or Pv6 addresses that distributed address pool service (DAPS) must not assign to
clients, use the exclude command in Pool IPv4 or IPv6 configuration submode. To remove the excluded IP
addresses, use the no form of this command.
exclude {first_address| last_address}
no exclude {first_address| last_address}
Syntax Description
Specifies the first address in the range that needs to
be excluded for IPv4 and specifies the first address
or prefix in the range for IPv6.
first_address
Specifies the last address in the range that needs to
be excluded and specifies the last address or prefix
in the range for IPv6.
last_address
Command Default
None
Command Modes
Pool IPv4 configuration
Pool IPv6 configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Support for IPv6 was added.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the pool ipv4 command to enter IPv4 pool configuration submode and pool ipv6 command to enter IPv6
pool configuration submode.
The low IP address cannot overlap with the IP address of a reserved address command. Multiple exclude
commands are allowed within a pool. To exclude a single address, <highIpAddress> can be omitted.
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
82
Address Pool Service Commands
exclude
To Next Page
Loading...
Need help?
General
