Cisco A9K-SIP-700 Command Reference

outer-cos
To reset the default outer-cos value for DHCPv4 control packets sent on BNG subscriber interfaces, use the
outer-cos command in DHCP IPv4 configuration mode. To set the outer-cos value back to the default value,
use the no form of this command.
outer-cos value
no outer-cos value
Syntax Description
Value of outer-cos for DHCPv4 control packets.
The range is from 0 to 7.
value
Command Default
None
Command Modes
DHCP IPv4 configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Task ID
OperationTask ID
read, writeip-services
Examples
This example shows how to reset the default outer-cos value for DHCPv4 control packets sent on BNG
subscriber interfaces:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dhcp ipv4
RP/0/RSP0/CPU0:router(config-dhcpv4)# outer-cos 0
Related Commands
DescriptionCommand
Resets the default inner-cos value for DHCPv4 control packets sent
on BNG subscriber interfaces.
inner-cos, on page 161
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
178
BNG DHCP Commands
outer-cos

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English