Cisco A9K-SIP-700 Command Reference

dhcp ipv6 (BNG)
To enable Dynamic Host Configuration Protocol (DHCP) for IPv6 and to enter DHCP IPv6 configuration
mode, use the dhcp ipv6 command in Global Configuration mode. To disable the DHCP for IPv6, use the no
form of this command.
dhcp ipv6
no dhcp ipv6
Syntax Description
This command has no keywords or arguments.
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.1.0
This command was supported for
BNG.
Release 4.3.0
Usage Guidelines
Use the dhcp ipv6 command to enter DHCP IPv6 configuration mode.
Task ID
OperationsTask ID
read, writeip-services
Examples
This example shows how to enable DHCP for IPv6:
RP/0/RSP0/CPU0:router(config)# dhcp ipv6
RP/0/RSP0/CPU0:router(config-dhcpv6)#
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
148
BNG DHCP Commands
dhcp ipv6 (BNG)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English