Cisco A9K-SIP-700 Command Reference

Command History
ModificationRelease
This command was introduced.Release 4.2.0
The idle-timeout event was added.Release 5.1
The exception event was added for service rollback failure due to
multi-action CoA request failure.
Release 5.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the policy-map type control subscriber command to enter policy-map configuration mode.
For idle-timeout event, you can configure the policy action as monitor under the idle timeout event for a
subscriber policy, to prevent the termination of the session.
The exception event with the action as disconnect, specifies that the subscriber sessions be removed when
a service rollback fails due to a multi-action Coa (MA-CoA) request failure. The default action is to retain
the session.
Task ID
OperationTask ID
read, writeqos
Examples
This example shows how to configure the event command in policy configuration mode:
RP/0/RSP0/CPU0:router(config)# policy-map type control subscriber pol1
RP/0/RSP0/CPU0:router(config-pmap)# event session-start match-first
RP/0/RSP0/CPU0:router(config-pmap-e)# class type control subscriber ip_dhcp do-until-failure
RP/0/RSP0/CPU0:router(config-cmap-c)# 1 activate dynamic-template ip_temp
RP/0/RSP0/CPU0:router(config-cmap-c)# 10 authorize aaa list default identifier format
dhcp_id_format password xya
RP/0/RSP0/CPU0:router(config-cmap-c)# end-policy-map
This example shows how to configure the idle-timeout event in policy configuration mode, with the action
as monitor for the subscriber policy:
RP/0/RSP0/CPU0:router(config)# policy-map type control subscriber pol1
RP/0/RSP0/CPU0:router(config-pmap)# event idle-timeout
RP/0/RSP0/CPU0:router(config-pmap-e)# class type control subscriber ip_dhcp
RP/0/RSP0/CPU0:router(config-cmap-c)# 1 monitor
This example shows how to configure the exception event in policy configuration mode, with the action as
disconnect:
RP/0/RSP0/CPU0:router(config)# policy-map type control subscriber PL1
RP/0/RSP0/CPU0:router(config-pmap)# event exception match-first
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
125
Control Policy Commands
event

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English