initiator unclassified-source
To enable unclassified packets as first-sign-of-life for IPv4 subscriber, use the initiator unclassified-source
command in the appropriate configuration submode. To disable this feature, use the no form of this command.
initiator unclassified-source
no initiator unclassified-source
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
IP subscriber IPv4 L2-connected configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Because packet-triggered L2 sessions are not supported for IPv6, this command is not supported for IPv6.Note
Task ID
OperationTask ID
read, writenetwork
Examples
This is an example of configuring the initiator unclassified-source command in the IP subscriber IPv4
L2-connected configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv4 l2-connected
RP/0/RSP0/CPU0:router(config-if-ipsub-ipv4-l2conn)# initiator unclassified-source
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
276
IPoE Commands
initiator unclassified-source
To Next Page
Loading...
Need help?
General
