session-limit (BNG)
To configure maximum simultaneous VPDN sessions, use the session-limit command in vpdn configuration
mode. To disable this feature, use the no form of this command.
session-limit number
no session-limit
Syntax Description
Specifies the number of sessions and the value can range between 1-131072.
number
Command Default
The default and max value for global session-limit is 65536(64k sessions).
Command Modes
VPDN configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vpdn command to enter vpdn configuration submode.
Per vpdn group session limiting is not supported on LAC.Note
If limit is configured after a number of sessions are up, then those sessions remain up irrespective of the limit
and new sessions will not come up based on the limit. The no form of the command results in removing limits
on number of sessions and new sessions are accepted by vpdn.
Task ID
OperationTask ID
read, writetunnel
Examples
This is an example of configuring the session-limit command in vpdn configuration mode:
RP/0/RSP0/CPU0:router# configure
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
418
PPPoE LAC-Specific Commands
session-limit (BNG)
To Next Page
Loading...
Need help?
General
