show pppoe interfaces
To display a summary of the protocol state for the specified PPPoE interface filtered by circuit-id, remote-id,
interface or location, use the show pppoe interfaces command in the EXEC mode mode.
show pppoe interfaces [circuit-id circuit_id | remote-id remote_id | access-interface type interface-path-id
| location node | all]
Syntax Description
Shows information for a given circuit-id.circuit-id
Specifies the circuit-id to show data for.
circuit_id
Show information for a given remote-id.remote-id
Specifies the remote-id to show data for.
remote_id
Shows PPPoE status for all sessions on a single access interface.access-interface
Interface type. For more information, use the question mark (?) online help
function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Shows PPPoE status for all sessions at a location.location
Specifies the fully qualified location specification.
node
Shows PPPoE status for all sessions.all
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
464
PPPoE Commands
show pppoe interfaces
To Next Page
Loading...
Need help?
General
