show pppoe throttles
To show the throttle information for the PPPoE sessions, use the show pppoe throttles command in the EXEC
mode mode.
show pppoe throttles [active] [access-interface type interface-path-id | bba-group bba-group-name | location
node]
Syntax Description
Shows only those throttles that are currently blocking packets.active
Shows PPPoE status for all sessions on a single access interface.access-interface
Interface type. For more information, use the question mark (?) online help
function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Shows throttles for all interfaces with a given bba-group.bba-group
Specifies the bba-group name.
bba_group_name
Shows PPPoE status for all sessions at a location.location
Specifies the fully qualified location specification.
node
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
The command output was extended for the throttle for circuit-id,
remote-id, inner-vlan, outer-vlan, vlan and circuit-id-and-remote-id.
Release 4.3.1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
475
PPPoE Commands
show pppoe throttles
To Next Page
Loading...
Need help?
General
