pppoe sessions limit
To set a limit for PPPoE sessions in a particular PPPoE BBA-Group, use the sessions limit command in
PPPoE BBA-Group configuration mode. To remove the specified limit for PPPoE sessions, use the no form
of this command.
sessions {access-interface| circuit-id| circuit-id-and-remote-id| inner-vlan| {mac| mac-iwf}
[access-interface]| max| outer-vlan| remote-id| vlan} limit limit-value [threshold threshold-value]
no sessions {access-interface| circuit-id| circuit-id-and-remote-id| inner-vlan| {mac| mac-iwf}
[access-interface]| max| outer-vlan| remote-id| vlan} limit limit-value [threshold threshold-value]
Syntax Description
Limits PPPoE sessions on any one access interface.access-interface
Limits PPPoE sessions with any one circuit-ID.circuit-id
Limits PPPoE sessions by circuit-id and remote-id.circuit-id-and-remote-id
Limits PPPoE sessions with any one inner-vlan id.inner-vlan
Limits PPPoE sessions from any one mac address.mac
Limits IWF PPPoE sessions from any one mac address.mac-iwf
Sets a per-card session limit.max
Limits PPPoE sessions with any one outer-vlan id.outer-vlan
Limits PPPoE sessions with any one remote-id.remote-id
Limits PPPoE sessions with matching vlan ids.vlan
Specifies the action of limiting the PPPoE sessions for various attributes.limit
Specifies the session limit value.
The range is from 1 to 65535. The default is 65535.
limit-value
Specifies the action of generating a log message when the threshold has
reached.
threshold
Specifies the threshold value.
The range is from 1 to 65535.
threshold-value
Command Default
None
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
457
PPPoE Commands
pppoe sessions limit
To Next Page
Loading...
Need help?
General
