Packet-triggered L2 session (initiator unclassified-source) is not supported for IPv6.Note
Task ID
OperationTask ID
read, writenetwork
Examples
This is an example of configuring the ipsubscriber l2-connected command in the interface configuration
mode for IPv4:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv4 l2-connected initiator dhcp
This is an example of configuring the ipsubscriber l2-connected command in the interface configuration
mode for IPv6:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv6 l2-connected initiator dhcp
This example shows how to enable subscriber IP uniqueness check during first-sign-of-life processing:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv4 l2-connected initiator unclassified-source
address-unique
Related Commands
DescriptionCommand
Displays the ipsubscriber information.show ipsubscriber summary, on page 293
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
281
IPoE Commands
ipsubscriber l2-connected
To Next Page
Loading...
Need help?
General
