Cisco A9K-SIP-700 Command Reference

clear igmp unicast-qos-adjust
To clear IGMP unicast rate adjustment database, use the clear igmp unicast-qos-adjust command in the
EXEC mode.
clear igmp unicast-qos-adjust {rate | statistics } interface {type | interface_path_id }
Syntax Description
Specifies the rate programmed in QoS.rate
Specifies the unicast rate adjustment statistics.statistics
Specifies the interface specific rate.interface
Interface type. For more information, use the question mark (?) online help function.
type
Either a physical interface instance or a virtual interface instance as follows:
•
Physical interface instance. Naming notation is rack/slot/module/port and a slash
between values is required as part of the notation.
◦
rack: Chassis number of the rack.
◦
slot: Physical slot number of the modular services card or line card.
◦
module: Module number. A physical layer interface module (PLIM) is always
0.
◦
port: Physical port number of the interface.
In references to a Management Ethernet interface located on a route
processor card, the physical slot number is alphanumeric (RP0 or RP1)
and the module is CPU0. Example: interface MgmtEth0/RP1/CPU0/0.
Note
•
Virtual interface instance. Number range varies depending on interface type.
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Command Default
Clears all unicast qos adjust parameters.
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
351
Multicast Commands
clear igmp unicast-qos-adjust

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English