Cisco A9K-SIP-700 Command Reference

process-failures switchover
To force a switchover in case of a process failure, use the process-failures switchover command in VPDN
redundancy configuration mode.
process-failures switchover
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
VPDN redundancy configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writetunnel
Examples
This is an example of enabling process-failures switchover.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# vpdn
RP/0/RSP0/CPU0:router(config-vpdn)# redundancy
RP/0/RSP0/CPU0:router(config-vpdn-redundancy)# process-failures switchover
RP/0/RSP0/CPU0:router(config-vpdn-redundancy)#
Related Commands
DescriptionCommand
Configures VPDN and enters the VPDN
sub-configuration mode.
vpdn, on page 424
Enables VPDN redundancy and enters the VPDN
redundancy configuration mode.
redundancy (BNG), on page 417
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
415
PPPoE LAC-Specific Commands
process-failures switchover

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English