lease
To set a client lease time on a per profile basis, use the lease command in DHCPv6 server profile configuration
mode. To disable the client lease time, use the no form of this command.
lease {days [hours minutes]| infinite}
no lease
Syntax Description
Specifies the number of days for the lease time. The value ranges from 1 to 365.
days
Specifies the number of hours for the lease time. The value ranges from 0 to 23.
hours
Specifies the number of minutes for the lease time. The value ranges from 0 to
59.
minutes
Specifies an infinite amount of lease.infinite
Command Default
By default, the lease is 86400 seconds (one day).
Command Modes
DHCPv6 server profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The lease time is applied to the class only and not to the whole profile. When both profile and class lease
times are present, then the class lease time is applied. The default lease time is 1 day, when no lease time
configuration exists.
The lease time is specified in seconds or date format.
Task ID
OperationTask ID
read, writeip-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
165
BNG DHCP Commands
lease
To Next Page
Loading...
Need help?
General
