initiator dhcp
To enable DHCP as first-sign-of-life protocol for IPv4 or IPv6 subscriber, use the initiator dhcp command
in the appropriate configuration submode. To disable this feature, use the no form of this command.
initiator dhcp
no initiator dhcp
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
IP subscriber IPv4 L2-connected configuration
IP subscriber IPv6 L2-connected configuration
IP subscriber IPv4 routed configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Supported was added for IPv6.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command is not supported for IPv6 routed subscriber.
Task ID
OperationTask ID
read, writenetwork
Examples
This is an example of configuring the initiator dhcp command in the Interface configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
RP/0/RSP0/CPU0:router(config-if)# ipsubscriber ipv4 l2-connected
RP/0/RSP0/CPU0:router(config-if-ipsub-ipv4-l2conn)# initiator dhcp
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
272
IPoE Commands
initiator dhcp
To Next Page
Loading...
Need help?
General
