Cisco A9K-SIP-700 Command Reference

ipsubscriber routed
To host IPv4 or IPv6 routed subscriber sessions in an access-interface, use the ipsubscriber routed command
in the interface configuration mode. To disable this feature, use the no form of this command.
ipsubscriber {ipv4| ipv6} routed [initiator {dhcp| unclassified-ip [prefix-len prefix-len]}]
no ipsubscriber {ipv4| ipv6} routed [initiator {dhcp| unclassified-ip [prefix-len prefix-len]}]
Syntax Description
Specifies IPv4 subscriber.ipv4
Specifies IPv6 subscriber.ipv6
Specifies session initiator for routed
subscriber.
initiator
Configures DHCP as the session
initiator for routed subscriber.
initiator dhcp is not
supported for IPv6 routed
subscriber sessions.
Note
dhcp
Configures unclassified packets as
first-sign-of-life for IPv4 or IPv6
subscriber.
unclassified-ip
Configures the prefix length of
IPv6 subscriber.
prefix-len
Specifies the prefix length of IPv6
subscriber.
The range is from 1 to 127.
prefix-len
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 5.1.1
Initiator unclassified-ip was added for the support of packet-triggered
IPv4 or IPv6 routed subscriber sessions.
Release 5.2.2
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
282
IPoE Commands
ipsubscriber routed

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English