accounting interim variation
To introduce a random delay between successive interim accounting messages of sessions or services in BNG,
use the accounting interim variation command in subscriber manager configuration mode. To remove this
random delay, use the no form of this command.
accounting interim variation value
no accounting interim variation
Syntax Description
Interim timeout randomization value, in percentage.
The range is from 0 to 50. By default, this value is zero (0), which means there is no
interim timeout randomization.
value
Command Default
By default, randomization is disabled.
Command Modes
Subscriber manager configuration
Command History
ModificationRelease
This command was introduced.Release 5.2.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Follow these usage guidelines while applying randomization:
•
Randomization cannot be applied for too small interim timeouts (that is, for timeouts less than 2 minutes).
•
If interim timeout is T seconds, the value x is selected from an interval [L, T]. By default, L is 100
percent of T (that is, 0% variance from T).
•
The maximum value of T- L is 900 seconds (that is, 15 minutes).
Task ID
OperationTask ID
read, writeconfig-services
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
513
Subscriber Commands
accounting interim variation
To Next Page
Loading...
Need help?
General
