show pppoe limits
To show the PPPoE session limit information, use the show pppoe limits command in the EXEC mode mode.
show pppoe limits [active] [access-interface type interface-path-id | bba-group bba-group-name | location
node]
Syntax Description
Shows only those throttles that are currently blocking packets.active
Shows PPPoE status for all sessions on a single access interface.access-interface
Interface type. For more information, use the question mark (?) online help
function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Shows throttles for all interfaces with a given bba-group.bba-group
Specifies the bba-group to show throttle for.
bba_group_name
Shows PPPoE status for all sessions at a location.location
Specifies the fully qualified location specification.
node
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
The command output was extended for the session limits of mac
access-interface, mac-iwf access-interface, inner-vlan, outer-vlan, vlan
and circuit-id-and-remote-id
Release 4.3.1
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
466
PPPoE Commands
show pppoe limits
To Next Page
Loading...
Need help?
General
