show pppoe statistics
To show the counters for packets received and sent by the PPPoE sessions, use the show pppoe statistics
command in the EXEC mode mode.
show pppoe statistics {access-interface| type| interface-path-id| internal | { location| node}| location| node}
Syntax Description
Shows PPPoE status for all sessions on a single access interface.access-interface
Interface type. For more information, use the question mark (?) online help
function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Shows internal PPPoE statistics.internal
Shows PPPoE status for all sessions at a location.location
Specifies the fully qualified location specification.
node
Command Default
None
Command Modes
EXEC mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator for assistance.
Task ID
OperationTask ID
readppp
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
470
PPPoE Commands
show pppoe statistics
To Next Page
Loading...
Need help?
General
