policy-map type control subscriber
To determine the list of events that are applicable to the subscriber lifecycle and to enter the policy-map
configuration mode, use the policy-map type control subscriber command in Global Configuration mode.
To disable the policy map type control subscriber and exit the policy-map configuration mode, use the no
form of this command.
policy-map type control subscriber policy-map name
no policy-map type control subscriber policy-map name
Syntax Description
Represents the policy map name.
policy-map name
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
From Cisco IOS XR Software Release 5.2.2 and later, you can edit the class associated with the subscriber
policy even while the sessions are active. Prior to this, new class map actions were not editable if the sessions
were up, and any such dynamic policy-map changes resulted in clearing off the subscriber sessions.
Task ID
OperationTask ID
read, writeqos
Examples
This is an example of configuring the policy-map type control subscriber command in the Global
Configuration mode:
RP/0/RSP0/CPU0:router(config)# policy-map type control subscriber pol1
RP/0/RSP0/CPU0:router(config-cmap-c)# end-policy-map
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
129
Control Policy Commands
policy-map type control subscriber
To Next Page
Loading...
Need help?
General
