EasyManuals Logo
Home>Cisco>Network Router>A9K-SIP-700

Cisco A9K-SIP-700 Command Reference

Cisco A9K-SIP-700
590 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #255 background imageLoading...
Page #255 background image
monitor-session interface configuration command or dynamic template configuration command to associate
this session with a specific source interface. For BNG sessions, the subscriber is attached to the monitor
session, only when the dynamic template is applied to the subscriber. When the session is associated, all
specified traffic on the interface is then replicated to the destination location defined in the monitor session
configuration.
The monitor-session interface configuration command also enters monitor session configuration mode for
you to configure additional features of the mirroring session.
If a physical interface is configured for Layer 3, then the traffic mirroring session can be associated on physical
interfaces. Example:
interface TenGigE0/1/0/0
ipv4 address 10.0.0.1 255.255.255.0
If a physical interface has sub-interfaces configured for Layer 3, then the traffic mirroring session must be
associated on each sub-interface. Example:
interface TenGigE0/1/0/1.601
ipv4 address 10.0.1.1 255.255.255.0
encapsulation dot1q 601
For more information about monitoring a session, see Configuring Traffic Monitoring chapter in Cisco ASR
9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide.
Task ID
OperationsTask ID
read, writeinterface
read, writeconfig-services
Examples
This example shows how to enter monitor session configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet0/0/0/11
RP/0/RSP0/CPU0:router(config-if)# l2transport
RP/0/RSP0/CPU0:router(config-if-l2)# monitor-session mon1
RP/0/RSP0/CPU0:router(config-if-mon)#
This example shows how to configure monitor-session command in the dynamic-template configuration
mode for BNG:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# dynamic-template type ppp ppp_template
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# monitor-session mon1 direction rx-only
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# acl
RP/0/RSP0/CPU0:router(config-dynamic-template-type)# mirror first 100
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
241
Dynamic Template Commands
monitor-session (interface-dynamic-template-BNG)

Table of Contents

Other manuals for Cisco A9K-SIP-700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco A9K-SIP-700 and is the answer not in the manual?

Cisco A9K-SIP-700 Specifications

General IconGeneral
BrandCisco
ModelA9K-SIP-700
CategoryNetwork Router
LanguageEnglish

Related product manuals