radius-server dead-criteria
To configure the dead server detection criteria for a configured RADIUS server, use the radius-server
dead-criteria command in the Global Configuration mode. To disable the Radius server dead-criteria, use
the no form of this command.
radius-server dead-criteria {time value| tries number_of_tries}
no radius-server dead-criteria {time value| tries number_of_tries}
Syntax Description
Specifies the minimum time that must elapse since a response was received from
this RADIUS server.
time
Specifies the time in seconds. The value ranges from 1 to 120.
value
Specifies the minimum number of transmissions (original attempts plus
retransmits) to this RADIUS server.
tries
Specifies the number of tries. The range is from 1 to 100.
number_of_tries
Command Default
None
Command Modes
Global Configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeaaa
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference, Release
5.2.x
33
BNG AAA Commands
radius-server dead-criteria
To Next Page
Loading...
Need help?
General
