Cisco A9K-SIP-700 Command Reference

ipsubscriber session-limit
To limit the number of IP subscriber sessions on a subscriber interface, use the ipsubscriber session-limit
command in the interface configuration mode. To disable this feature, use the no form of this command.
ipsubscriber session-limit{total| unclassified-source}per-vlan session_limit
no ipsubscriber session-limit
Syntax Description
Limits IP subscribers for all sources.total
Limits IP subscribers for unclassified sources.unclassified-source
Limits the per VLAN subscribers.per-vlan
Specifies the maximum number to which of the IP subscriber session
can be limited.
session-limit
Command Default
None
Command Modes
Interface configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writenetwork
Examples
This is an example of configuring the ipsubscriber session-limit command in the interface configuration
mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 56
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Command Reference,
Release 5.2.x
284
IPoE Commands
ipsubscriber session-limit

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English