190-01115-01 G3X/G3X Touch Installation Manual - Engine/Airframe Sensor Installation
Rev. AC Page 23-5
The Engine inputs being monitored are displayed as gauges on the EIS display (Figure 23-1) and also on
the MFD Engine Page.
Figure 23-1 EIS Display (Engine Bar)
The following list of gauges, (if configured) are specifically required by FAR 91.205 and will always be
displayed on the EIS display (engine bar). Other gauges will be displayed as space permits based on a pre-
defined priority and user selections.
RPM Oil Temperature Oil Pressure
Fuel Quantity
RPM
Electronic Ignition N/A 1-4 pulses/revolution
Jabiru Alternator Output N/A Single phase, 6 pulses/revolution
JPI 4208XX (Slick/
Bendix magneto,
pressurized)
N/A
Rotax Trigger Coil N/A
UMA 1A3C-2 N/A
UMA 1A3C-4 N/A
UMA T1A9-1 (Slick
magneto)
494-50005-00
UMA T1A9-2 (Bendix
magneto)
494-50005-01
Turbine engine RPM
(requires Sandia ST26
signal converter)
N/A
Uses custom user-defined
calibration (0-1000 Hz to RPM)
Any frequency-output
RPM sensor
N/A
Uses custom user-defined
calibration (0-1000 Hz to RPM)
Turbine Inlet /
Outlet /
Interstage
Temperature
(TIT/TOT/ITT)
Type K thermocouple N/A
Table 23-1 Compatible Engine/Airframe Input Sensors
SENSOR TYPE
COMPATIBLE
SENSORS
GARMIN PART
NUMBER*
NOTES
*Items with a Garmin part number may be included in a G3X Sensor Kit (Section 23.2), and are
available individually from Garmin Dealers
To Next Page
Loading...
Need help?
General
