190-01115-01 G3X/G3X Touch Install Manual - GDU 4XX Config and Post Install Checkout
Rev. AC Page 34-33
34.4.7 AOA (Angle of Attack) Configuration Page
The AOA Configuration page is accessible only when an AOA input is enabled on the LRU Configuration
page (Section 34.4.4
). This configuration mode page only allows viewing and deleting the AOA
calibration values, and changing the Show AOA Above and Hide AOA on Ground Below settings.
The AOA calibrations must be performed in-flight and the calibration procedures cannot be performed
using this configuration mode page.
The Show AOA Above and Hide AOA on Ground Below settings adjust the speed at which the AOA
information (Figure 34-6) will appear on the display.
1. In configuration mode (Section 34.2
), use the Touch Panel or a Move Selector Knob to select and
view the AOA Configuration Page.
2. Use the Touch Panel or a Move Selector Knob to make the desired changes.
3. Press the Back key to return to the Configuration Mode page when finished (if desired).
Figure 34-6 AOA Configuration Page