Siemens SCALANCE XR-300WG User Manual

5.2.2.1 ntp
Description
With this command, you change to the Network Time Protocol (NTP).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ntp
Result
You are now in the NTP configuration mode.
The command prompt is as follows:
cli(config-ntp)#
Further notes
You exit the NTP configuration mode with the end or exit command.
5.2.3 Commands in the NTP configuration mode
This section describes commands that you can call up in the NTP configuration mode.
In the Global configuration mode, enter the ntp command to change to this mode.
● If you exit the NTP configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the NTP configuration mode with the end command, you return to the Privileged
EXEC mode.
System time
5.2 NTP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
150 Configuration Manual, 07/2017, C79000-G8976-C361-06

Siemens SCALANCE XR-300WG Specifications

General

Brand	Siemens
Model	SCALANCE XR-300WG
Category	Switch
Language	English