Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
11.5.3.1 dot1x guest-vlan
Description
With this command, you enable the guest VLAN function for a port.
This function is also known as "Authentication failed VLAN".
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
dot1x guest-vlan
Result
The guest VLAN function is enabled for a port.
Further notes
You also need to enable the guest VLAN function for the device. You do this with the dot1x
guest-vlan command in the Global configuration mode.
You disable the function with the no dot1x guest-vlan command.
You display this setting and other information with the show dot1x command.
11.5.3.2 no dot1x guest-vlan
Description
With this command, you disable the guest VLAN function for a port.
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 529
To Next Page
Loading...
Need help?
General