8.4.4.1 show hrp counters
Description
With this command, you display the following information:
● How often the device as redundancy manager switched to the active status, i.e. opened its
blocked port because it no longer receives its sent RM frames.
● The maximum delay time of the test frames of the redundancy manager.
● How often the IE switch has changed the standby status from "Passive" to "Active".
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show hrp counters
Result
The counters are displayed.
8.4.4.2 show linkcheck
Description
With this command you show the following information on the link check:
● The ring ports on which you can enable Link Check
● The current status
● The statistics of sent and received Link Check frames of the monitored connections.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
392 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General