Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command for the port to be monitored with the following parameter assignment:
no monitor session <session-id(1-1)> source
{interface <interface-type><interface-id>} [{rx|tx|both}]}
The parameters have the following meaning:
Parameter Description Range of values / note
session-id Number of the session 1
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
rx Received data traffic will be mirrored
(received)
-
tx Transmitted data traffic will be mirrored
(transmitted)
-
both Received and transmitted data traffic
will be mirrored
-
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default value (both) is used.
Result
The source for the mirroring of a port is deleted.
Further notes
You configure the source for mirroring a port with the monitor session ... source
command.
You end and delete a session with the no monitor session command.
You display the configuration settings with the show monitor session command.
12.5.2.9 no monitor session
Description
With this command, you delete the monitor session.
Diagnostics
12.5 Port Mirroring
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
596 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General