With RMOB events. the SNMP notifications to be called must be configured explicitly, see
section "RMON (Page 576)".
7.5.1 The "show" commands
This section describes commands with which you display various settings.
7.5.1.1 show snmp
Description
This command shows the status information of SNMP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show snmp
Result
The status information is displayed.
7.5.1.2 show snmp community
Description
This command shows the details of the configured of SNMP communities.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 323
To Next Page
Loading...
Need help?
General