The parameters have the following meaning:
Parameter Description Range of values / note
aa:aa:aa:aa:aa:aa MAC address of the interface -
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show mac-address-table static unicast command, you display the list of
configured entries.
With the mac-address-table static unicast command, you create an entry.
8.5.3 The "show" commands (Transparent Bridge)
This section describes commands with which you display various settings.
8.5.3.1 show dot1d mac-address-table
Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table [address <aa:aa:aa:aa:aa:aa>]
[{interface <interface-type> <interface-id>}]
Layer 2 management protocols
8.5 Unicast
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 415
To Next Page
Loading...
Need help?
General