The parameters have the following meaning:
Parameter Description Range of values / note
vlan-id Number of the addressed VLAN 1 ... 4094
vlan-id Number of the addressed VLAN 2 ... 4094
Enter a space before and after the hyphen, e.g. vlan range 5 - 10.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The command prompt is as follows:
CLI(config-vlan-range)#
Configuration commands you enter with this command prompt apply to all selected VLANs.
Further notes
With the command exit, you return to the Global configuration mode.
6.1.3 Commands in the Interface configuration mode (VLAN Bridge)
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
6.1.3.1 private-vlan mapping
Description
With this command you specify from which secondary PVLANs the IP interface of the primary
PVLAN will be reachable.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
178 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General