The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ip address dhcp
Result
The IP address is assigned using DHCP.
Further notes
You delete the setting with the no ip address command.
7.2.3.2 no ip address
Description
With this command, you delete the assignment of an IP address and disable DHCP.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip address [{ <ucast_addr> | dhcp }]
The parameter has the following meaning:
Parameter Description Range of values / note
ucast-addr Value for an IPv4 unicast address Enter a valid IPv4 unicast address.
dhcp Specify this parameter if you want to
disable the DHCP function explicitly.
-
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Network protocols
7.2 DHCP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
286 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General