Requirement
● The VLAN must not be assigned to a physical port.
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameter:
no vlan <vlan-id(1-4094)>
Parameter Description Range of values / note
vlan-id Number of the addressed VLAN 1 ... 4094
The VLAN with number 1 cannot be deleted.
Result
The VLAN is deleted
Further notes
With the vlan command, you create a VLAN on the device.
You can display information about the VLAN with the show vlan command.
6.1.2.7 vlan range
Description
With this command, you can select several VLANs and configure them together. The
configurations are valid for all selected VLANs.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan range <vlan-id(1-4094)> - <vlan-id(2-4094)>
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 177
To Next Page
Loading...
Need help?
General