The parameters have the following meaning:
Parameter Description Range of values / note
rate-value Value for the in data rate in Kbps The value range depends on the
port speed. The entry is rounded
down to the next valid value. If
small values are entered, the val‐
ue is rounded up to the next valid
value.
Default:
The data rate is set to 0. The in‐
coming data stream is not limited.
Result
The value for the storm control function is configured.
Further notes
You can reset the setting to the default with the no storm-control level command.
10.1.2.6 no storm-control level
Description
With this command, you reset the value for the storm control function to the default value.
The default value for the storm control level is 0 Kbps. The incoming data stream is not limited.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no storm-control level
Result
The value for the storm control function is reset to the default.
Load control
10.1 Rate control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 459
To Next Page
Loading...
Need help?
General