The parameter has the following meaning:
Parameter Description Range of values
gateway Specifies the IP address of the gateway enter a valid IP address
Result
The entry is configured.
Further notes
You delete the default gateway with the no ip gateway command.
You show the default gateway with the show ip gateway command.
7.1.2.2 no ip gateway
Description
With this command, you delete the default gateway.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip gateway <gateway>
The parameter has the following meaning:
Parameter Description Range of values
gateway Specifies the IP address of the gateway. Specify a valid IP address.
Result
The entry is deleted.
Further notes
You configure the default gateway with the ip gateway command.
You show the default gateway with the show ip gateway command.
Network protocols
7.1 IPv4 protocol
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 273
To Next Page
Loading...
Need help?
General