The parameters have the following meaning:
Parameter Description Range of values/note
address Keyword for a MAC address -
aa:aa:aa:aa:aa:aa MAC address Specify a valid MAC ad‐
dress.
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
8.5.3.2 show dot1d mac-address-table static unicast
Description
This command shows the table with the static unicast MAC addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table static unicast [address
<aa:aa:aa:aa:aa:aa>]
[{interface <interface-type> <interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
address Keyword for a MAC address -
aa:aa:aa:aa:aa:aa MAC address -
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
Layer 2 management protocols
8.5 Unicast
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
416 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General