Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip
dhcp-server
pool
[{
<pool-id
(1-24)>
|
[{
vlan
<vlan-id
(1-4094)>
| <interface-type> <interface-id> }]}]
The parameters have the following meaning:
Parameter Description Range of values / note
pool-id ID of the addressed IPv4 address band 1 ... 24
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
interface-type Type of interface Specify a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the exit command.
You delete the entry with the no ip dhcp-server pool command.
7.3.2.6 no ip dhcp-server pool
Description
With this command, you delete the required IPv4 address band.
Network protocols
7.3 DHCP server
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 293
To Next Page
Loading...
Need help?
General