You display this setting and other information with the show dot1x command.
11.5.3.11 no dot1x mac-auth vlan-assign
Description
With this command you disable the assignment of the VLAN ID for a MAC address by the
RADIUS server.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x mac-auth vlan-assign
Result
The VLAN ID for a MAC address is no longer assigned by the RADIUS server.
Further notes
You enable the assignment of the VLAN ID for a MAC address by the RADIUS server with the
dot1x mac-auth vlan-assign command.
You display this setting and other information with the show dot1x command.
11.5.3.12 set dot1x mac-auth mac-addr count
Description
With this command, you specify how many MAC addresses can be authenticated on the port
at the same time.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
536 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General