Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no ports [<interface-type> <0/a-b, 0/c, ...>] [<interface-type> <0/a-
b, 0/c, ...>] [all]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface
0/a-b,0/c,... Port no. of the interface
all All ports will be disabled. -
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The selected ports will be disabled.
Further notes
You enable the ports with the ports command.
You display the setting with the show ip dhcp-server pools command.
You enable the IPv4 address band with the pool-enable command.
7.3.3.10 relay-information
Description
With this command you define that devices with a certain remote ID and circuit ID are assigned
the IPv4 addresses from a specific address band.
If you create such an entry for an address band, address pool only reacts to DHCP queries
via a DHCP relay agent (option 82). You can create further address bands for the same IP
interfaces so that the pools react to different requests.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
Network protocols
7.3 DHCP server
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
302 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General