has the same effect as:
CLI#conf t
CLI(config)#int vlan 1
CLI(config-if-vlan-1)#no ip address dhcp
CLI(config-if-vlan-1)#ip address 192.168.1.1 255.255.255.0
CLI(config-if-vlan-1)#end
CLI#write startup
2.9.4.7 The "show" commands
This section describes commands with which you display various settings.
show history
Description
This command shows the last 14 commands you entered.
The commands are listed in the order in which they were called up. The show history
command is listed as the last command to be entered.
The list depends on the mode. In the Global configuration mode, the last 14 commands entered
in this mode are displayed. These commands are not included in the list of the Interface
configuration mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show history
Result
The list of used commands is displayed.
2.9.4.8 clear history
Description
This command deletes the last commands you entered.
General information
2.9 General CLI commands
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
44 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General