Result
The IP ARP table is displayed.
7.9.2 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
7.9.2.1 arp timeout
Description
With this command, you configure the timeout setting of the ARP cache.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
arp timeout <seconds(30-86400)>
The parameter has the following meaning:
Parameter Description Range of values / note
seconds Value for the timeout in seconds 30 ... 86400
Default: 300
Result
The setting for the timeout setting of the ARP cache is configured.
Further notes
You can reset the timeout setting to the default with the no arp timeout command.
Network protocols
7.9 ARP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
364 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General