11.5 Port Based Network Access Control
This section describes commands for working with port-based network access control (PNAC).
11.5.1 The "show" commands
This section describes commands with which you display various settings.
11.5.1.1 show dot1x
Description
This command shows information about port-based network access control (PNAC).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show dot1x[{interface<interface-type><interface-id>|
statistics interface<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
statistics
interface
Keyword for the display of the statistical
data of the dot1x Authenticator for an
interface
-
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The dot1x information is displayed.
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
524 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General