EasyManua.ls Logo

Siemens SCALANCE XR-300WG User Manual

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show versions
Result
The version information of the entire system is displayed.
3.1.2 clear counters
Description
With this command, you reset the counters of an interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
clear counters [<interface-type><interface-id>]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Specify a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If no parameters are specified, the counters for all interfaces are reset.
Result
The counters of the interface are reset.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 59

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XR-300WG and is the answer not in the manual?

Siemens SCALANCE XR-300WG Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XR-300WG
CategorySwitch
LanguageEnglish

Summary

Introduction

General information

System functions hardware equipment

Table showing availability of system functions across different SCALANCE models.

Configuration

System settings

Describes commands for displaying and configuring general system properties.

Saving and loading configurations and firmware

Covers commands for displaying, copying, saving, and downloading files.

Functions specific to SCALANCE

System time

System time setting

Describes commands relevant for configuring the system time.

Network structures

VLAN

Describes commands for configuring and managing virtual networks (VLANs) and private VLANs.

Network protocols

IPv4 protocol

Describes commands of the Internet Protocol version 4.

DHCP client

Covers commands for configuring the DHCP client and its options.

Layer 2 management protocols

IGMP snooping

Layer 3 functions

NAT

Load control

Rate control

Static MAC filtering

Security and authentication

User management

Diagnostics

Event and fault handling

Related product manuals