Syntax
Call up the command with the following parameters:
show rmon [statistics [<stats-index (1-65535)>]] [alarms] [events]
[history [history-index (1-65535)] [overview]]
The parameters have the following meaning:
Parameter Description Range of values / note
statistics Shows counts for various packet char‐
acteristics and sizes.
-
stats-index Index number for the statistical values 1 ... 65535
alarms Shows the threshold values and event
assignments for alarms.
-
events Shows the status and the actions that
are triggered.
-
history Shows the stored statistical values for
earlier transmission periods.
-
history-index Index number for the previous statistical
values
1 ... 65535
overview Displays an overview. -
With this command, you can display several parameters with one call.
If you do not select any parameters from the parameter list, only the enabled or disabled
status is shown.
Result
The settings of the remote monitoring function are displayed.
12.4.2 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
12.4.2.1 rmon
Description
With this command, you enable the Remote Monitoring function.
Diagnostics
12.4 RMON
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 577
To Next Page
Loading...
Need help?
General