Siemens SCALANCE XR-300WG User Manual

The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show spanning-tree detail
Result
The detailed settings for the spanning tree function are displayed.
6.3.1.5 show spanning-tree interface
Description
This command shows the settings of the ports for the spanning tree function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show spanning-tree interface <interface-type><interface-id>
[{cost|priority|portfast|rootcost|restricted-role|
restricted-tcn|state|stats|detail}]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
cost Shows the port costs used to calculate
the lowest-cost path.
-
priority Shows the priority of the port. -
portfast Shows whether spanning-tree
portfast is enabled.
-
rootcost Shows the costs of the path to the root
bridge.
-
restricted-role Shows whether spanning-tree
restricted-role is enabled.
-
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 221

Siemens SCALANCE XR-300WG Specifications

General

Brand	Siemens
Model	SCALANCE XR-300WG
Category	Switch
Language	English

Summary

Introduction

General information

System functions hardware equipment

Table showing availability of system functions across different SCALANCE models.

Configuration

System settings

Describes commands for displaying and configuring general system properties.

Saving and loading configurations and firmware

Covers commands for displaying, copying, saving, and downloading files.

Functions specific to SCALANCE

System time

System time setting

Describes commands relevant for configuring the system time.

Network structures

VLAN

Describes commands for configuring and managing virtual networks (VLANs) and private VLANs.

Network protocols

IPv4 protocol

Describes commands of the Internet Protocol version 4.

DHCP client

Covers commands for configuring the DHCP client and its options.

Layer 2 management protocols

IGMP snooping

Layer 3 functions

NAT

Load control

Rate control

Static MAC filtering

Security and authentication

User management

Diagnostics

Event and fault handling