The parameters have the following meaning:
Parameter Description Range of values / note
aa:aa:aa:aa:aa:aa MAC address of the interface -
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
0/a-b, 0/c,... Module no. and port no. of the interface
port-channel Specifies the name of a port channel 1-8
forbidden-ports Keyword for the interface description of
the blocked ports
-
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry in the forwarding database is generated.
Further notes
With the show mac-address-table static multicast command, you display the list
of configured entries.
With the no mac-address-table static multicast command, you delete an entry.
8.6.2.2 no mac-address-table static multicast
Description
With this command, you delete a static multicast address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no
mac-address-table
static
multicast
<aa:aa:aa:aa:aa:aa>
vlan
<vlan-
id(1-4094)>
Layer 2 management protocols
8.6 Multicast
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 425
To Next Page
Loading...
Need help?
General