The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
set dot1x guest-vlan mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Parameter Description Range of values / note
num-of-addresses Maximum number of MAC addresses 1 ... 100
Result
The maximum number of MAC addresses for the port has been specified.
Further notes
You display this setting and other information with the show dot1x command.
11.5.3.7 dot1x mac-auth
Description
With this command, you enable MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
dot1x mac-auth
Result
MAC authentication is enabled for a port.
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 533
To Next Page
Loading...
Need help?
General