The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show forward-unregistered
Result
The entries of the GMRP forward unregistered table are displayed.
8.1.2 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.1.2.1 gmrp
Description
With this command, you enable the GMRP function for all or individual interfaces on the
device.
Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Syntax
Call the command without parameters:
gmrp
Layer 2 management protocols
8.1 GARP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 371
To Next Page
Loading...
Need help?
General